Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
USER MANUAL
ENGLISH
Front and rear skirt check
5.
Remove the main broom, as shown in the relevant
paragraph.
6.
Check the front (1, Fig. R) and rear (2) skirts for
integrity.
7.
Replace the skirts when they have cuts (1, Fig. N)
larger than 20 mm or cracks (2) larger than 10 mm
(for skirt replacement, refer to the Service Manual).
8.
Check that:
– The front skirt (1, Fig. R) slightly touches the
ground and that it is not detached from the ground
(1, Fig. P).
– The rear skirt (2, Fig. R) height from ground is
within 0 - 3 mm (1, Fig. O).
9.
If necessary, adjust the skirt height by using the slots
(3, Fig. R).
10. Press the front skirt lifting pedal (8, Fig. C) and check
that the front skirt (1, Fig. Q) rotates upward of about
90° (as shown in figure); release the pedal and check
that the skirt does not remain in an intermediate
position but returns to its initial position. If necessary,
for the front skirt control cable adjustment or
replacement, refer to the Service Manual.
11. Assemble in the reverse order of disassembly.
HOOD SAFETY SWITCH OPERATION
CHECK
While the engine is running, slightly open the hood (10,
Fig. C) and check that the engine stops immediately.
If opening the hood (10) does not cause the engine to
stop, contact an authorised Service Center or Retailer.
16
FLOORTEC R 360 P
SAFETY FUNCTIONS
The machine is equipped with the following safety
functions.
EMERGENCY PUSH-BUTTON
It is located in an easily accessible position (8, Fig. B). It
has to be pressed in case of emergency, to stop all the
machine functions.
HOOD SAFETY SWITCH
WARNING!
When it is necessary to open the hood to
perform service procedures, be sure to
remove the key from the ignition switch.
It activates when the machine hood is opened: It stops all
functions.
If the machine keeps operating when the hood is open,
contact an authorised Service Center or Retailer
immediately.
DRIVER'S SEAT MICROSWITCH
It is located inside the driver's seat and it does not allow
the machine drive system to operate if the operator is not
seated on the driver's seat.
146 2598 000(2)2006-06 A
Advertenties
Hoofdstukken
Inhoudsopgave
