Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
USER MANUAL
ENGLISH
SIDE BROOM HEIGHT CHECK AND
ADJUSTMENT
NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
1.
Check the side broom height from the ground,
according to the following procedure:
– Drive the machine on a level ground and lower the
side brooms.
– Keep the machine stationary and rotate the side
brooms for a few seconds.
– Stop and lift the side brooms, then move the
machine and switch it off.
– Check if the size and orientation of the prints left
by the side brooms are as shown in the figure (1
and 2, Fig. J). If the print is not within
specifications, it is necessary to adjust the broom
height, according to the procedure shown in step
2.
2.
Unlock the ring nut (40, Fig, C) by turning it
counterclockwise, then turn the knob (33) as
necessary, clockwise or counterclockwise, to adjust
the broom height; then lock the knob (33) with the ring
nut (40).
3.
Perform step 1 again to check the proper adjustment
of the side broom height from the ground.
4.
When the brooms are too worn to be adjusted,
replace them as shown in the next paragraph.
14
FLOORTEC R 360 P
SIDE BROOM REPLACEMENT
NOTE
Brooms of various hardness are available. This
procedure is applicable to all types of brooms.
CAUTION!
It is advisable to use protective gloves
when replacing the side brooms because
there can be sharp debris between the
bristles.
1.
Drive the machine on a level ground and engage the
parking brake (6 and 7, Fig. C).
2.
Turn the ignition switch (2, Fig. B) to "0" position.
3.
Introduce the hand inside the side broom and press
the tabs (1, Fig. K) inwards, then remove the broom
(2) disengaging it from the four pins (3).
4.
Install the new broom on the machine engaging it on
the pins (3) and on the tabs (1).
5.
Carry out the side broom height check and
adjustment, as shown in the previous paragraph.
146 2598 000(2)2006-06 A
Advertenties
Hoofdstukken
Inhoudsopgave
