USER MANUAL
ENGLISH
INTRODUCTION
MANUAL PURPOSE AND CONTENTS
The purpose of this Manual is to provide the operator with
all necessary information to use the machine properly in a
safe and autonomous way. It contains information about
technical data, operation, storage, maintenance, spare
parts and safety.
Before carrying out any procedure on the machine, the
operators and qualified technicians must read this Manual
carefully. Contact an authorised Nilfisk Service Center in
case of doubts regarding the interpretation of the
instructions and for any further information.
TARGET
This Manual is intended for operators and technicians
qualified to perform the machine maintenance.
HOW TO KEEP THIS MANUAL
The User Manual must be kept near the machine, inside
an adequate case, away from liquids and other
substances that can cause damage to it.
IDENTIFICATION DATA
The machine model and serial number are marked on the
plate (1, Fig. U) applied on the frame and can be read by
lifting the hood (4).
The machine model year is written in the EC statement
and it is also indicated by the first two figures of the
machine serial number.
The petrol engine serial number and model are marked in
the positions (2 and 3, Fig. U).
This information is useful when ordering machine spare
parts. Use the following table to write down the machine
and engine identification data for any further reference.
MACHINE model ..........................................................
MACHINE serial number .............................................
ENGINE model.............................................................
ENGINE serial number .................................................
2
FLOORTEC R 360 P
OTHER REFERENCE MANUALS
Petrol Engine Manual, supplied with the machine, which is
to be considered an integral part of this Manual.
Moreover, the following Manuals are available:
–
Spare Parts List (supplied with the machine)
–
Service Manual (that can be consulted at Nilfisk
Service Centers)
SPARE PARTS AND MAINTENANCE
All necessary operating, maintenance and repair
procedures must be carried out by qualified personnel or
by Nilfisk Service Centers listed at the end of this
Manual. Only original spare parts and accessories must
be used.
Contact Nilfisk for service or to order spare parts and
accessories, specifying the machine model and serial
number.
CHANGES AND IMPROVEMENTS
Nilfisk constantly improves its products and reserves the
right to make changes and improvements at its
discretion without being obliged to apply such benefits to
the machines that were sold previously. Any change
and/or addition of accessory must be approved and
performed by Nilfisk.
146 2598 000(2)2006-06 A