Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Options - Side-guards (continued)
Side-guard with clothes protector
The clothes protector prevents clothes getting dirty from
spray water, (Fig.42).
You can set the position in relation to the rear wheel by
moving the side-guard.
To do this, remove the screws (1 and 2).
After setting to the desired position, re-tighten the screws
(see the page on torque).
WARNING!
Neither the side-guards nor the armrests are to be used
for lifting or carrying the wheelchair.
Options - Push Handles
Height-adjustable push handles
These handles are secured with pins to prevent them
from sliding out unintentionally. By releasing the tension
lever (1) the height of the push handles (2) can be set
individually. If the lever is moved, listen to make sure that
it clicks into place. The push handle can easily be set to
the desired position. The nut on the tension lever
determines how tightly the push handles are clamped into
place. If the nut is loose after adjusting the tension lever,
the push handle will also be too loose. Turn the push
handle from side to side before use to make sure that it is
clamped into place securely. After adjusting the handle
height, always clamp the tension lever (1) securely into
place. If the lever is not secure, injuries could result when
ascending stairs. (Fig. 43).
CAUTION!
If the height-adjustable push handles are not fitted
properly, there is a risk that these will develop "play" or
that they move out of position. Please make sure that the
relevant screws are tightened correctly.
Folding push-handles
If the folding push handles are not required, they can be
flipped downwards by pushing the button (1). When they
are required again, flip the push handles up, until they
click into place. (Fig. 44).
XENON FF
Fig. 42
Fig. 43
Fig. 44
1
25
1
2
2
1
Rev.2.0
Advertenties
Hoofdstukken
Inhoudsopgave
