Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Options - Side-guards
1. Fitting
a. Push the outer armrest rails down into the receiver
which is mounted on the wheelchair frame.
b. The armrest will automatically lock into place.
2. Height adjustment
a. Turn the release lever for height adjustment (2) to the
second stop point.
b. Push the armpad up or down to reach the desired
height.
c. Set the lever back to the interlocked position against
the armrest rails.
d. Push the armpad (4) until the rails click into place
securely.
3. Remove the armrest
a. Operate the lever 3 and lift the whole arm.
4. Insert armrest
a. Put the armrest back in the receiver, until the arm clicks
into place.
Mounting Components For The Armrest
Receiver
Adjusting the armrest receiver
To tighten or loosen the fit of the outer armrest rails in the
receiver:
1. Loosen the four set screws for the receiver (D) on the
sides of the receiver.
2. Leave the armrest in the receiver (E) and push the
receiver together, until the desired adjustment is achieved.
3. Tighten the four screws (D). (144 in-lbs, 16.3 Nm)
Position adjustment
1. Loosen the two clamp screws (10) until the clamp is
loose.
2. Push the armrest receiver to the desired position.
3. Tighten.
(Fig.38, 39, 40 and 41).
1. Outer armrest rails
2. Height adjustment of the locking lever
3. Locking lever
4. Armrest pad
5. Transfer bar
6. Side-guard
7. Receiver
8. Adjustment clamp
9. Parts to adjust the receiver
10. Clamp screws
XENON FF
Fig. 38
2
3
1
7
Fig. 39
Fig. 40
Fig. 41
E
24
4
5
6
9
1
Rev.2.0
Advertenties
Hoofdstukken
Inhoudsopgave
