Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Width adjustment of footrests
Fig. 18
If the footrest width needs to be adjusted, please undo
the screw (1), set the desired width, by positioning 1, 2 or
3 spacers (2) from outer to the inner side and then refit
the screws, (Fig.18).
Lightweight footrest
The footboard angle can be adjusted by loosening the
screws (2). Side protection panels can be fitted to the
1
2
footboard using the mounting holes (3) These prevent the
feet slipping off accidentally, (Fig.19). Make sure that
after any adjustment work, all screws are tightened
Fig. 19
correctly (see the page on torque).
3
Width adjustment
3
2
To adjust the width of the footboard open the screw (2).
Then you can slide in and out the tubes in the holder to
adjust the width of the footboard (Fig.19).
2
Please make sure that the screws are tightened with the
correct torque .
Automatic folding footrest
The footrest angle can be adjusted by loosening the
screws (1) and turning the footrest. When tightening,
please note the torque measurements, (Fig.20).
High-mount footrest
The high-mount footrest is fitted on the inner part of the
frame and permits a higher position than a standard
footrest (Fig. 21)
Fig. 20
1
Fig. 21
XENON FF
Rev.2.0
18
Advertenties
Hoofdstukken
Inhoudsopgave
