Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Quick Release Wheels
Quick-release axles on rear wheel
The rear wheels are equipped with quick-release axles. The wheels
can then be fitted or removed without using tools. To remove a
wheel, simply depress the quick-release button on the axle and pull
the wheel off the axle. (Fig. 7).
CAUTION!
Hold the quick-release button on the axle depressed when
inserting the axle into the frame to mount the rear wheels.
Release the button to lock the axle in place. The quick-release
button should snap back to its original position.
Options - Step Tubes
Step tubes are used by attendants to push a wheelchair
over an obstacle. Simply step on the tube to push a wheelchair, for
example, over a kerb or step, (Fig.8).
Options - Brakes
CAUTION!
Braking power can be
affected by incorrect fitting and
adjustment of the brakes, as well as tyre pressure which is too low.
Wheel locks
Your wheelchair is equipped with two wheel locks. They are applied
directly against the tyres. To engage, press both brake levers
forward against the stops. To release the locks, pull the levers back
to their original positions.
Braking power will decrease with:
•
Worn tyre tread
•
Tyre pressure that is too low
•
Wet tyres
•
Improperly adjusted wheel locks.
The wheel locks have not been designed to be used as brakes for a
moving wheelchair. The wheel locks should therefore never be
used to brake a moving wheelchair. Always use your hands for
braking. Make sure that the gap between the tyres and wheel locks
complies with given specifications. To readjust, loosen the screw
and set the appropriate gap. Then re-tighten the screw
(Fig. 9 and 10).
CAUTION!
After each adjustment of the rear wheels, check the wheel lock gap
and re-adjust if necessary.
XENON FF
Fig. 7
Fig. 8
Fig. 9
Fig. 10
15
3.0mm
Rev.2.0
Advertenties
Hoofdstukken
Inhoudsopgave
