Inhoudsopgave
Advertenties
34 EMC-richtlijnen en verklaringen van de fabrikant
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
The 901106 is intended for use in the electromagnetic environment specified below. The customer or the user of the
901106 should assure that it is used in such an environment.
Immunity test
Electrostatic discharge
(ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and
voltage variations on
power supply input
lines
IEC 61000-4-11
Power frequency(50/
60Hz)magnetic field
IEC 61000-4-8
The 901106 is intended for use in the electromagnetic environment specified below. The customer or the user of the
901106 should assure that it is used in such an environment.
Immunity test
Electromagnetic emissions
Not applicable
Not applicable
Electromagnetic immunity
IEC 60601 test level
Compliance level
±8 kV contact
± 8 kV contact
± 15 kV air
± 15 kV air
±2 kV for power supply
Not applicable.
lines
±1 kV for input/output
lines
± 1 kV differential
Not applicable.
mode
± 2 kV common mode
Not applicable.
>95% dip in 0.5 cycle
60% dip in 5 cycles
30% dip for 25 cycles
>95% dip in 5 seconds
3 A/m
Not applicable.
Electromagnetic immunity
IEC 60601 test level
Compliance level
®
Welch Allyn Connex
-apparaten - ECG-module
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic
tile. If floors are covered with synthetic
material, the relative humidity should be at
least 30%.
Electromagnetic environment - guidance
Portable and mobile RF communications
equipment should be used no closer to any part
of the 901106, including cables, than the
recommended separation distance calculated
from the equation applicable to the frequency
of the transmitter.
Advertenties
Inhoudsopgave
