Advertenties
3. | User Information
• Never exceed the maximum permissible voltage load of 42 V peak alternating voltage (AC) or 60 V direct current
voltage (DC) respectively.
• Do not exceed the voltage limits indicated on the connecting cables.
• The voltage values to be measured must be shielded extra or even twice from dangerous line voltage. The voltage
limits printed on the test leads must not be exceeded. Pay attention that the allowed measuring range of 60 V/DC / 42
V peak is not exceeded when measuring positive and negative voltage at the same time.
• Never perform measurements on ignition systems.
• Regularly check the test and measuring devices for damage.
• Always connect the test and measuring devices to the measurement module (MT-USB) first.
• Do not touch the connections/measurement points during the measurement.
3.1.6. Safety Precautions – Risk of Injury
When working on the vehicle, there is a risk of injury through rotating parts or rolling of the vehicle. Therefore regard the
following:
• Protect vehicle against rolling away.
• Additionally place gear selector lever of AT vehicles to park position.
• Deactivate the start/stop system to avoid an inadvertent engine startup.
• Connect the device to the vehicle only when ignition is switched off.
• Do not reach into rotating parts while the engine is running.
• Do not run cables near rotating parts.
• Check the high-voltage parts for damage.
318
Hella Gutmann
mega macs X
Advertenties
Probleemoplossen
