Inhoudsopgave
Advertenties
Configuring
The configuration of the
conditioner carried out in the
factory will be checked when the
conditioner is first energized, and must
not be further modified. Only qualified
MGE UPS personnel are allowed
access.
The screen opposite is displayed after
pressing F2 to confirm memorisation of
the new parameters
MGE UPS SYSTEMS
MAIN MENU
Language / langue
Principle measurements
Secondary measurements
Alarms
Configuration
JBUS communication
Identification
Reserved access
1 Choose the Configuration option
using the
and
2 Confirm the Configuration option by
pressing the ENT key.
CONFIGURATION MENU
Current sensor 1000/1
Neutral connected
ON/OFF JBUS validated
Reactive compensated
?
Mem
Harmonics choice
Application: 0005
Nb of // units: 2
Mains voltage: 400 V
Derating %: 10
Sensor connected
4 Choose the parameter to be
modified using the
and press ENT.
For example, modification of the rating
of the sensors used to measure load
currents.
SENSOR SIZE CHOICE
Current sensor 300/1
Current sensor 500/1
Current sensor 600/1
Current sensor 1000/1
Current sensor 1500/1
Current sensor 2000/1
Current sensor 3000/1
Current sensor 4000/1
5 Choose the sensor rating using the
arrows and press ENT.
MEMORIZATION
Confirmation: ENT
Escape: ESC
WARNING: Memorization
= STOP of SineWave
7 Confirm memorization by pressing
ENT or cancel modifications in
progress by pressing ESC.
installation and operation manual of SineWave™: E-51027008XT/AD
Enter
password:
3 Enter the password (4 characters)
then press ENT.
keys.
The Configuration Menu screen is
again displayed for modification of
other parameters if required
CONFIGURATION MENU
Current sensor 1000/1
Neutral connected
ON/OFF JBUS validated
Reactive compensated
?
Harmonics choice
Application: 0005
Nb of // units: 2
Mains voltage: 400 V
Derating %: 10
and
keys
Sensor connected
6 Press F2 "Mem" key to memorise
the new parameters.
Memorization in progress
This screen is displayed while the
parameters are being saved, wait a few
seconds for the general menu to be
displayed before starting the
SineWave™ up again.
CONFIGURATION
* * * *
The password characters are
displayed by an "*".
Mem
MEMORIZATION
33
Advertenties
Hoofdstukken
Inhoudsopgave
