Advertenties
6.5. Resets
6.5.1. Factory Reset
To reset the system to factory settings, press and hold the reset button (see 2.3 Device description) for >10 seconds
and release it again. The control panel LEDs will go out after a few seconds and the system will restart. After the
restart, the alarm panel is reset to the factory settings and can be set up again.
6.5.2. User-Reset
To reset the users of the system or delete all users from the system, press the left tamper contact (above the reset
button) 5 times within 5 seconds. After a few seconds, the Internet LED briefly switches to red. You should receive a
push notification on the connected devices that the relevant gateway has been removed.
When all LEDs are green again (Internet LED may flash green), you can add the system again using the + symbol in
your app.
6.6. Function of the LEDs
The LED displays listed below only apply after initial start-up of the system
Note
Power LED: Shows the power supply status and can signal faults
Colour
Green
Red
Orange
Internet LED (globe): Shows the status of the cloud connection
Colour
Green
Red
Flashing green
Network LED (arrows): Shows the communication channel currently in use
Colour
Green
Red
Status LED (padlock): Shows system status
Colour
Red
Orange
Green
Flashing green
Meaning
Mains power supply
Battery operation
Firmware update
Meaning
Connected to the cloud
(Owner is created)
Connection to the cloud failed
Connected to the cloud
(No owner created)
Meaning
Connected to the internet via LAN
3G/4G connection
Meaning
System armed
System partially armed
System disarmed
Control panel is connecting to
component
|29
Advertenties
