Advertenties
3.2. Putting the system into operation
3.2.1. Preparing the hardware
•
Slide the left cover downwards and the right cover upwards to open the
housing.
If you want to use a hard drive, SIM card or SD card, insert it before the next step (adding the mains
voltage).
Note
Format your SD card or hard drive in exFAT or NTFS format before inserting it. Never work on the SD
card or hard drive while the control panel is booting.
Note
•
Connect the emergency power battery
•
Connect the Ethernet cable & network cable to the control panel to establish the
power and network connection and wait until the 4 LEDs on the control panel light
up (this can take up to 40 seconds).
•
Close the housing using the two front covers
|10
Advertenties
