Download Print deze pagina

ABAC PAT ZERO Handleiding pagina 52

Advertenties

6
• Assemble the wheels and the foot, or the swivel wheel for models on which it is featured.
For the versions with fixed feet, assemble the front clamp kit or the vibration dampers, if included.
• Check for correspondence between the compressor plate data with the actual specifications of the electrical
system. A variation of ± 10% with respect of the rated value is allowed.
• Insert the power plug in a suitable socket checking that the button of the pressure switch (5) located on the
compressor is in the "O" (OFF) position (figures F-G).
• For the 3-phase versions, connect the plug to a panel protected by suitable fuses.
• At this point, the compressor is ready for use.
• Operating on the switch of the pressure switch (5) the compressor starts, pumping air in the reservoir
through the delivery hose.
• On reaching maximum operating pressure (factory-set during testing), the compressor stops, venting the
excess air present in the head and in the delivery hose through a valve located under the pressure switch
(in delta/star versions, through an electrovalve that is activated when the motor stops).
•The absence of pressure in the head facilitates subsequent restart. When air is used, the compressor
restarts automatically when the lower calibration value is reached (approx. 2 bar between upper and lower).
The pressure inside the reservoir can be checked on the gauge (8) provided.
• The compressor continues to operate automatically with this work cycle until the position of the switch of the
pressure switch (5) figures F-G) is modified. To use the compressor again, wait at least 10 seconds after
this has been switched off before restarting.
• Air pressure can be regulated in order to optimize use of air-powered tools operating on the knob with the
valve open (pulling it up and turning it in a clockwise direction to increase pressure and counterclockwise to
reduce this) (fig. I). Once you have set the value required, push the knob down to lock it.
• The value set can be checked on the gauge
• Please check that the air consumption and the maximum working pressure of the pneumatic tool to be used
are compatible with the pressure set on the pressure regulator and with the amount of air supplied by the
compressor.
• When you have finished working, stop the machine, pull out the plug and empty the reservoir.
START-UP AND USE
(8).
52
GB

Advertenties

loading

Gerelateerde Producten voor ABAC PAT ZERO