Inhoudsopgave
Advertenties
12.6 Setup
12.6.1
Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the
setup location must fulfil the following prerequisites:
• The device must be set up on a firm, flat and horizontal surface with
sufficient load-bearing capacity for the vacuum sealer system and the
maximum weight of the food that should be vacuum-sealed.
• Choose the setup location in such a way that children cannot reach the
hot sealing strip of the device.
• Do not set up the device in a hot, wet or extremely damp environment
or near flammable material.
• The device requires an adequate flow of air in order to operate
correctly. Leave a clearance of 10 cm around the device.
• Do not move the vacuum sealer system when it is in operation.
• The electrical socket must be easily accessible so that the power lead
can be disconnected easily, in the case of an emergency.
• The installation and assembly of this device in non-stationary setup
locations (e.g. on ships) must be carried out by specialist companies /
electricians, provided they guarantee the prerequisites for the safe use
of this device.
12.7 Electrical connection
In order to ensure the safe and trouble-free operation of the device, the
following instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage
and frequency) on the rating plate with those of your electrical network.
This data must agree in order that no damages occur in the device.
If in doubt, ask your qualified electrician.
• The electrical outlet must be protected by a 16A safety cut-out switch.
• The connection between the device and the electrical network may
employ a 3 meter long (max.) extension cable with a cross-section of
1.5 mm². The use of multiple plugs or gangs is prohibited because of
the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been
installed under the oven or over hot or sharp surfaces.
• The electrical safety of the device is only guaranteed if the device is
connected to a properly installed protective conductor system.
Operations using an electrical outlet without a protective conductor are
prohibited. If in doubt, have the house installation checked over by a
qualified electrician.
caso Vakuumierer VC220
42
Advertenties
Inhoudsopgave
