Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
m
CAUTION! Risk of injury!
Do not use any broken, cracked, or
u
otherwise damaged grinding wheels .
Never operate the product without
u
protective equipment .
Support the plates or workpieces in
u
order to reduce the risk of kickback
from a jammed cutting wheel
workpieces may bend under their own
weight . The workpiece must be supported
on both sides of the wheel, not only near
the cutting wheel, but also at the edge .
Keep your hands away from the wheel
u
when the product is in operation . Risk of
injury .
NOTE
Information on replacement
Never operate the product without
u
protective equipment .
Ensure that the rotation speed stated on
u
the tool is the same or higher than the
nominal idle speed of the product .
Ensure that the tool dimensions match
u
those of the product .
Only use flawless wheels (ringing test:
u
when you strike the grinding wheel with
a plastic hammer, it results in a clear
sound) .
Never re‑drill a locating hole which is too
u
small to make it larger .
Never use separate bushings or adapters
u
in order to make grinding wheels with a
hole that is too large fit the product .
Do not use any saw blades .
u
NOTE
To clamp the grinding tools only use the
u
clamping flange provided . The pads
between the clamping flange and the
grinding tools must be made of elastic
materials e .g ., rubber, soft cardboard etc .
Reassemble the product completely after
u
replacing the tool .
. Large
6 ]
[
˜ Switching on and off
m
WARNING!
Make sure that the mains supply voltage
u
matches the voltage rating indicated on
the product's type plate .
m
WARNING! Risk of injury!
The tool still runs even after the product
u
has been switched off .
1 . Connect the mains plug
socket‑outlet .
2 . To start, push the on/off slide switch
(Fig . A) forwards along the product before
pressing it into the product's grip surface .
3 . After switching on the product, wait until the
product has reached its max . speed . Start
working only now .
4 . To switch off, release the on/off slide
switch
Trial run
Always carry out a trial run without a load
o
before carrying out your first procedure as
well as after every tool change .
Switch the product off immediately if the
o
tool is not rotating smoothly, if considerable
vibration occurs, or if you hear abnormal
noises .
to a
9 ]
[
. The product switches off .
3 ]
[
GB/IE/NI
3 ]
[
19
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
