Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Removing the attachment
1 . Release the attachment for the protective
cover
by pushing the notch
[
7a ]
from the protective cover
2 . Unscrew the attachment
protective cover
7 ]
[
˜ Installing/changing the
wheel
(Fig . F)
NOTE
If the rotary direction is indicated on
u
your wheel, ensure that it corresponds
to the rotary direction of the product
when mounting . The rotary direction
is indicated on the product next to the
spindle lock button
Ensure that the mounting flange
u
(Fig . B) is placed on the product in
such a way that the recesses in the
flange grip into the edge of the product .
The mounting spindle
simultaneously when you turn the flange .
1 . Press the spindle lock button
2 . Turn the mounting spindle
spindle lock fixed the mounting spindle .
Keep and continue to hold down the
spindle lock button
3 . Release the clamping nut
key
. You can release the spindle lock
10 ]
[
button
.
8 ]
[
4 . Set the desired wheel onto the mounting
flange
(Fig . B) . The label on the wheel
[
11 ]
should always face the product .
5 . Set the clamping nut
spindle
again . The flat side of the
13 ]
[
clamping nut must face the attachment
tool if the thickness of the wheel receptor is
< 5 mm .
If the thickness of the wheel receptor is
≥ 5 mm, turn the clamping nut
18 GB/IE/NI
away
18 ]
[
.
7 ]
[
from the
7a ]
[
.
(
) .
[
8 ]
11 ]
[
must turn
13 ]
[
.
[
8 ]
until the
13 ]
[
.
[
8 ]
with the chuck
[
12 ]
on the mounting
[
12 ]
(Fig . B) .
12 ]
[
6 . Press the spindle lock button
the mounting spindle
lock button holds the spindle flange in a
fixed position . Pull the clamping nut
again using the chuck key
go of the spindle lock button .
˜ Operation
m
WARNING!
Switch off the product and remove
the mains plug
to cool down .
m
WARNING!
Wear protective gloves when
changing the tool so as to avoid
injuries from cuts .
m
WARNING!
The clamping nut
u
screwed too tightly so as to avoid
breaking the wheel and nut .
m
CAUTION! Risk of injury!
Always remove the mains plug
u
working on the product .
Only use grinding wheels and
u
accessories recommended by the
manufacturer . Using other attachment
tools and other accessories can represent
a risk of injury for you .
Only use accessory parts which bear
u
information about the manufacturer, type
of connection, dimension and permitted
number of revolutions .
Only use accessory parts where the
u
printed rotational speed is at least as
high as what has been specified on the
name plate of the product .
and turn
8 ]
[
, until the spindle
13 ]
[
tight
[
12 ]
. You can let
[
10 ]
. Allow the product
[
9 ]
must not be
[
12 ]
before
9 ]
[
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
