Download Inhoudsopgave Inhoud Print deze pagina

Applications; Intended Use - BLUE ECO Titanium 240 Handleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

national and international regulations, guidelines and engineer standards. Never open the housing of the device or attached
parts if not explicit stated in the manual .Use original spare parts and accessories only. Repairs must be executed by trained
service persons only. DO NOT pump any liquids beside water. In the case of questions or problems, for your own safety,
contact trained service persons.
Unplug the pump from main power before service and/or maintenance!

Applications

The BLUE ECO pump was designed for fresh-, brackish- or salt water, or other low viscosity liquids which are neither explosive nor
aggressive or oily. The pump may be used for clean water and in a limited way also for contaminated water. The pump is not intended
for water with coarse debris. Particles should not be larger than 0.8 mm. Basically the pump is intended for use with „clean water"
without solid particles which may damage the bearings, like, for example sand and pyrolusite after the treatment of ponds with potas-
sium permanganate. Warranty does not apply for damages resulting from above described particles. The bearings of the pump are
milled spirally to evacuate particles larger than 0.8 mm. The bearing plate contains enough space for a filter. The filter must be cleaned
regularly regardless the degree of soiling. A special amount of water is flushing the pump housing to ensure long term operation of the
pump. To decrease the flow rate in the housing, perfectly close the plate and adjust to the smallest dot on the plate. Now the bearing
lubrication by water is very low.
The most common applications of the Blue Eco pump are to operate a filter system (ponds or swimming pools) and/or for circulation
of a stream or waterfall. The pump is not self-priming, but with the aid of a non-return valve on the suction line below the water level it
can be installed above the water level. However, the suction line must be prefilled with water.

Intended use

• Liquid temperature: 0 to +40°C.
• Environmental temperature: max. +55 °C
• Maximum operation pressure: 2 bar

Advertenties

Inhoudsopgave
loading

Inhoudsopgave