Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Blue Eco Manual | English
Signal port
1
Source current of 5 Volt
2
DC control current 0-10 volt
3
Program inlet TXD
4
Program in Program inlet let RXD
5
GND
6
NC
7
NC
8
NC
If this port is used, the pump must be set to UAM. The cable may not be connected yet. This can be done in the following way:
1. Press 'MENU': System appears on the display.
2. Press 'SELECT': timer mode appears on the display.
3. Press the up arrow to go to Panel Command Source.
4. Press 'SELECT': the display starts flashing.
5. Press the up arrow to go to UAM Command Source.
6. Press 'ENTER'; Alert Keydata Modified appears on the display.
7. Press 'RESET' at the top right; UAM appears.
8. Now connect the network cable, and you can control the pump via the external cable.
You can set the pump to back to manual by going to UAM Command Source in step 3 and Panel Command Source in step 5.
0-10V Connection
2
5
Advertenties
Inhoudsopgave
