Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Blue Eco Manual | English
Gebruikte symbolen
CAUTION – HIGH VOLTAGE
IGNORING THIS INSTRUCTION MAY HARM USER AND/OR ANIMALS.
CAUTION
IGNORING THIS INSTRUCTION MAY DAMAGE THE PUMP AND/OR OTHER DEVICES ATTACHED.
Not intended use
This manual is intended to give you brief information about the device. The user, installer or maintenance personal, is solely responsible
for the strict adherence of all instructions made in this manual. The BLUE ECO was manufactured according state-of-the art technology
and current safety regulations. Nevertheless this device may involve risks for life and physical condition if not used as intended or if
safety regulations were ignored. If not used as intended, our liability expires as well as the general operating license. Children, youth
below an age of 16 as well as persons who may not recognize possible risks or who are not familiar with this manual must not use the
device for safety reasons. Please keep this manual safe and hand out in the case of change of proprietor. The combination of water and
electricity may severely harm life and physical condition if the device was not connected properly or used inappropriate.
Do not use the device as long as persons remain in the water! Unplug all devices in the water before touching the water!
Check the specification of the mains against the electrical specifications on the package or the label of device. Make sure the
device is connected to a fault current detection switch with a fault leakage below 30 mA (DIN VDE 0100T739) Use the device
only if plugged into a wall plug installed according to regulations). Keep the power plug and all connections dry! Install
cables dry and save to avoid damage.
DO NOT CUT OR TRIM THE CABLE OR PLUG OF THE DEVICE; CLAIMS AND WARRANTY EXPIRE IMMEDIATELY!.
Only use cables, adapters, installations, extension cords or power cables which are designed for outdoor use (DIN VDE 0620)
and with a proper cable diameter. Do not pull or carry the device on the cables! In the case of a defective cable or housing,
the device must not be used! Protect cables and accessories against heat, oil, UV light and sharp objects. The manufacturer
cannot be held liable for damages resulting from unintended or inappropriate use or negligence of the user or installer.
Damages to the power plug or the housing remains the device unusable. Repairs are impossible due to the fact that the
cables were cast into the housing. Keep the connectors dry. In the case the connector got wet or humid it must be rinsed in
demineralised water and must be carefully dried by a trained service person.
Generally the pump must be cleaned carefully before put out of operation. At return of service check clearance of the impel-
ler. If the impeller cannot be moved the pump must be disassembled and cleaned. DO NOT unplug the power plug while
operating the pump and the controller. This may result in severe damage of the internal electronics and dangerous hazards
due to grounding problems. The controller must be connected to a safety fault current detector (30mA) and a properly
installed wall plug. Do not modify or replace any cables. Electric installations on garden ponds must be in accordance with
Advertenties
Inhoudsopgave
