Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
PROBLEM
POSSIBLE CAUSE
The dishwasher has not finished the
phase of heating of the water in the
tank
Water in the tank is excessively dirty
The washing arms of the rotor (fig.
18) knock the parts to be washed
protruding from the basket
The rotor needs cleaning
The nozzles of the rotor are blocked.
No detergent
Excessive hardness of the inlet water
The tank is stained with coffee or
grease
Use of detergent with high content of
chlorine
Using bleach in the tank
Introduction into the tank of crockery
previously cleaned with iron scourers
Washing of dishes or iron items
SOLUTION
Before starting actual washing, wait for
the water heating time in the wash tank.
When the pre-set water temperature is
reached, the WATER TEMPERATURE LIGHT
comes on
Change the water
Place the dishes so that they do not
become hit by the washing arms of the
rotor by following the instructions in para.
3.4 – PART TWO
Wash and rinse the rotor
Wash and rinse the nozzles of the rotor.
Contact the installer to increase the
amount of rinse aid.
Contact the installer to install a softener
upstream
Perform descaling of the tank with specific
products
for
Follow the instructions provided by the
manufacturer of the descaling agent.
WARNING RISK OF BURNS
Increase daily water refills and contact
the installer to increase the amount of
detergent.
Change the type of detergent according
to the instructions given in paragraph 11.
Remove rust with specific products
without scratching the surface of the
steel
Never use bleach.
Remove rust with specific products
without scratching the surface of the
steel
Never use scouring pads or wire brushes
in the manual pre-wash. Remove rust
with specific products without scratching
the surface of the steel
Do not wash iron items
35
industrial
dishwashers.
ATTENTION!
FROM ACID
EN
35
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
