Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Under counter dishwasher basket 450-500-600
G90 (cycle for glasses 90 sec.)
C110 (cycle for small cups 110 sec.)
C120 (cycle for plates 120 sec.)
C300 (cycle for cutlery 300 sec.)
EN
Object washer
C120 (cycle for plates 120 sec.)
C150 (intensive cycle for trays 150 sec.)
C240 (cycle for pans 240 sec.)
C540 (cycle for baking trays 540 sec.)
Lid dish washer (60-90-120-300 sec.)
C90 (short cycle for plates 60 sec.)
C90 (cycle for plates 90 sec.)
C120 (cycle for plates and cutlery 120 sec.)
C300 (cycle for cutlery 300 sec.)
4.6.1 Energy Saving
After 30 minutes of inactivity, the dishwasher goes into Energy Saving mode, lowering the
temperature in the tank to 40°C and the boiler to 60°C. This way, keeping the temperature lower
than the work temperature enables energy saving.
To exit the Energy Saving state, simply press any key or open and close the door.
It is possible to adjust the amount of time to wait before the dishwasher enters Energy Saving.
Contact an authorised service centre to change the settings.
4.7 End of service
Every day, after use:
If the dishwasher has no drain pump installed
1. Open the door and remove the overflow tube and re-close the door.
2. Briefly press the ON/OFF KEY (2) to switch the dishwasher off (the display will show the message
prompting removal of the overflow)
3. After a few seconds a tank-cleaning cycle will start automatically that lasts approximately 2
minutes that will rinse the tank and will cool the boiler.
4. At the end of the self-cleaning cycle, the dishwasher switches off automatically.
5. To switch the dishwasher off without running the self-cleaning cycle, press and hold down the
ON/OFF KEY
If the dishwasher has a drain pump installed
1. Open the door and remove the overflow tube and re-close the door.
2. Press and hold the DRAIN PUMP KEY (6) until the tank drain and self-cleaning cycle starts. The self-
cleaning cycle will start automatically as soon as the tank is empty. This cycle takes approximately
2 minutes and will rinse the tank and cool the boiler.
3. At the end of the self-cleaning cycle, the dishwasher switches off automatically.
As soon as the dishwasher is turned off
1. remove the electric power by turning off the main switch installed upstream of the dishwasher or
disconnect it from the electric network
2. Remove and clean the wash pump filter (fig. 17) and any tank filters if present
3. carefully clean the wash tank
4. check and, if necessary, unscrew and clean the wash and rinse pipes
5. replace all the dishes removed, proceeding in reverse order
28
28
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
