Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5 Instructions for disassembly
EN
INJURY HAZARD
DAMAGE HAZARD FOR THE DISHWASHER
Only skilled personnel should be allowed to disassemble the dishwasher.
The dishwasher should therefore be taken to the nearest authorised dealer to disassemble all or part
of the dishwasher.
6 Maintenance
INJURY HAZARD
BURN HAZARD
MAINTENANCE MUST ONLY BE CARRIED OUT WHEN THE MACHINE IS SWITCHED OFF, DISCONNECTED
FROM THE POWER SUPPLY NETWORK AND THE TANK IS EMPTY.
MOREOVER, MAINTENANCE SHOULD ONLY BE CARRIED OUT AFTER THE HEATING ELEMENTS HAVE
COOLED DOWN (WAIT AT LEAST FIVE MINUTES).
THE ONLY EXCEPTION TO THIS RULE IS WHEN CHECKING THAT THE MICROSWITCH IS FUNCTIONING (SEE
THE TABLE BELOW).
The table below shows a list of the necessary maintenance operations and their frequency.
In case of technical problems, contact your Dealer.
MAINTENANCE
Wash tank cleaning
Rotor cleaning
Wash pump filter
cleaning
Cleaning of wash
tank filters (if present)
Rotor rotation
check
Outer
surfaces
cleaning
M i c r o s w i t c h
functioning check
30
ATTENTION!
ATTENTION!
FREQUENCY
NOTES
Daily
To be carried out with care.
Dismantle the rotor by unscrewing the retaining nut and
pulling it upwards (fig.18). Wash the rotor with water.
Daily
Carry out the same operations for the upper rotor.
Remove the wash pump filter by pulling it upwards, then
Daily
wash it and rinse it (fig. 19).
Remove the wash tank filters by pulling them upwards
Daily
then wash and rinse them.
Daily
Check manually that the rotor rotates freely.
Every 1-2 days
Do not use solvents on the control panel.
Check that the door microswitch works properly when
Weekly
the machine is on by opening/closing the door or by
lifting/lowering the lid.
30
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
