Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability for
damage to the product or caused by the product arising
from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE0113 not being observed.
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your product and to use it for its intended
purpose.
The operating manual includes important instructions for
the safe, proper and economic operation of the product,
for avoiding danger, for minimising repair costs and
downtimes and for increasing the reliability and extend-
ing the service life of the product.
In addition to the safety instructions in this operating
manual, you must also observe the regulations applica-
ble to the operation of the product in your country.
Keep the operating manual package with the power tool
at all times and store it in a plastic cover to protect it
from dirt and moisture. They must be read and carefully
observed by all operating personnel before starting the
work.
The product may only be used by personnel who have
been trained to use it and who have been instructed with
respect to the associated hazards.
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such products must also be observed.
We accept no liability for accidents or damage that oc-
cur due to a failure to observe this manual and the safe-
ty instructions.
3
Product description (Fig. 1-24)
1.
Handle
2.
On/off switch
3.
Locking switch
4.
Laser ON/OFF switch
5.
Sawing shaft lock
6.
Saw head
7.
Moving saw blade guard
7a.
Fixing screw
8.
Saw blade
9.
Laser cover
10.
Laser
11.
Moveable stop rail
12.
Stop rail
13.
Table inlay
14.
Handle / locking screw for rotary table
15.
Adjustment screw
16.
Pointer
17.
Scale
18.
Rotary table
19.
Fixed saw table
20.
Locking screw for workpiece support
21.
Workpiece support
22.
Longitudinal stop
23.
Set screw for the sliding stop rail
24.
Locking screw
25.
Clamping device
25a. Locking screw for clamping device height adjust-
ment
25b. Knurled screw for clamping device height adjust-
ment
25c. Locking screw for clamping device
26.
Angle scale
27.
Angle pointer
28.
Cable routing
28a. Slide rail locking screw
29.
Guide bar
30.
Dust bag
31.
Screw for limiting cutting depth
31a. Knurled nut for limiting cutting depth
32.
Stop for cutting depth limiting
33.
Tilt protection
34.
Locking pin
35.
Adjustment screw (90°)
35a. Locknut (90°)
36.
Adjustment screw (45°)
36a. Counternut (45°)
37.
Flange screw
38.
Outer flange
39.
Inner flange
40.
Laser cover Philips screw
41.
Philips screw table inlay
42.
Transport handle
GB / IE / NI
|
3
Advertenties
Hoofdstukken
Inhoudsopgave
