Inhoudsopgave
Advertenties
Product overview
1
Engine
2
Throttle interlock
3
Ignition switch
4
Throttle safety button
5
Throttle trigger
6
Main handle
7
Ignition coil
8
Ventilation slot
9
Handle bar
10 Handle bar connector
11 Lock pin
12 Cutting shaft
13 Trimming guard
14 Gear box
15 Brushcutting guard
16 Cutting means
17 Spark plug connector
18 Choke lever
19 Air filter box
20 Fuel tank cap
21 Fuel tank
22 Recoil starter
23 Harness connector
24 Engine shaft
25 Auxiliary handle
26 Clamp
27 Locking knob
HANDLE BAR
1
Remove the handle bar connector 10
screws and attach the handle bar 9.
Attach the main handle 6 to the handle
bar 9 by use of the main handle screw.
Use the zip ties to route the ignition
coil 7 along the handle bar 9.
152
GB
Intended Use
Equipped with a cutting blade for brushcut-
ting and the brushcutting guard, the machine
is intended to cut weeds, brush, small trees
and similar vegetation with a thickness of up
to 20 mm.
Equipped with a trimmer head for trimming
and the trimming guard, the machine is in-
tended to cut small weeds, grass or similar
soft vegetation.
Any other use or modification to the machine
is considered as improper use and could
cause considerable dangers. The machine
should not be used on unusual thick, dry or
wet material.
The machine is not intended for commercial
use.
CUTTING SHAFT
2
Press the locking pin 11 and slide the
cutting shaft 12 into the clamp 26.
Slide in until the locking pin 11 clicks
in place and securely tighten the lock-
ing knob 27. The cutting shaft 12 can
be fixed in 3 working positions.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
