Inhoudsopgave
Advertenties
• Direction of rotation switch (7)
NOTICE! Only operate the direction
of rotation switch when the tool
has stopped!
The arrow on the direction switch
(7) indicates the working direction.
•
Screw in screw, drill
• Centre Switch lock
•
Unscrew screw
• Torque adjustment ring (3)
Setting the maximum screwing
torque at which the slip clutch trig-
gers.
NOTICE! Only operate the torque
adjustment ring when the tool has
stopped!
• 1 Lowest torque
• 21 Maximum torque
For safety, start screwing at low
torque. Increase the torque as
required.
• Gear selector switch (6)
NOTICE! Only operate the gear se-
lector switch when the tool has
stopped.
• 1 Screws
• 2 Drill bits
• On/Off switch (17)
• After inserting the battery: Con-
necting to the PARKSIDE app
• Switching on: Press
• Infinitely variable speed regula-
tion: The more you press the on/
off switch, the higher the speed.
• Switching off: Release
• "Connected" display (16)
Status of the connection with the
PARKSIDE app
flashing connection attempt
continuous light connection es-
tablished
• Function selection switch (5)
Set the function selector switch (5)
so that the arrow mark points to
the desired symbol.
NOTICE! Risk of damage! Only op-
erate the function selector switch
when the tool has stopped.
Function
Symbol
Drilling (Strik-
ing mechan-
ism OFF/without
speed limitation)
Hammer drilling
(Percussion ON)
Screwing (strik-
ing mechanism
OFF)
Attaching and removing the
attachment tool
Notes
• Chuck capacity: 1.5-13 mm
• The direction of rotation is en-
graved in the keyless chuck (2).
Attaching the attachment tool
1. Open the drill chuck: RELEASE➞
2. Push the attachment tool as far as
possible into the drill chuck open-
ing (1).
3. Clamp the attachment tool: ⬅GRIP
Removing the attachment tool
1. Open the drill chuck: RELEASE➞
2.
CAUTION! Risk of burn injury!
Attachment tools – especially drills
– can become very hot. Wear pro-
tective gloves whenever appropri-
ate.
Remove the attachment tool.
Using a ratchet screwdriver/
screwdriver bit holder
1. Place the desired screwdriver bit
(32) in the ratchet screwdriver (27)/
screwdriver bit holder (28).
GB
MT
33
Advertenties
Hoofdstukken
Inhoudsopgave
