Inhoudsopgave
Advertenties
E8
Overcurrent on the cutting motor.
E9
Error in the charging status.
E10
Overvoltage/undervoltage.
E11
Tilt sensor activated.
E12
Flat obstacle.
E13 or
Overheating.
"HOT"
F1
The robot does not start. Signal present
F2
The robot does not start. No signal (charging
station).
F3
The robot does not start. The charging contacts are
defective.
F4
Battery voltage too low.
Restart the robot:
1) Place the robot on the boundary wire.
2) Enter the security code.
3) Activate the Start button.
Further troubleshooting
Manual_FX-RB218_Int24_rev1
45
Is the grass too high? Is the blade
disc blocked? Restart the robot.
Malfunction of the battery. Please
contact Fuxtec customer service.
Malfunction of the battery. Please
contact Fuxtec customer service.
Is the tilt angle over 20 degrees?
Restart the robot.
Circle the obstacle with the
boundary wire. Restart the robot.
To protect the battery from
overheating (high outside
temperature), the mower should be
parked in the shade.
Is the robot outside the boundary
wire? Is the boundary wire
connected correctly?
Is the boundary wire/power supply
connected correctly?
Clean the charging tentacles and
copper plates. If the voltage is
between
28 - 32 V Please contact Fuxtec
customer service.
Fully charge the robot.
Advertenties
Inhoudsopgave
