Inhoudsopgave
Advertenties
Charging station
•
You must also clean the charging station regularly by removing dirt and grass from the base plate to avoid poor
contact between the charging contacts of the charging station and the robot.
•
It is important to check that the respective charging contacts are correctly connected to each other.
•
Over time, the charging station may sink a little as the surface sinks due to the decomposition of the grass.
Charging contacts
•
Clean the charging contacts on the robotic lawnmower and charging station a few times during the season with fine
emery paper or steel wool.
It is important to ensure that all bolts, screws and nuts are always correctly tightened so that the
robotic mower has the best possible working conditions.
Replacing spare parts:
Blades:
•
The blades have 2 sharp edges and can be rotated if they have become blunt on one edge.
•
If both edges are blunt, the blades can be easily replaced with a screwdriver.
Note: Remember to switch off the mains switch before you start working on the appliance.
•
Once you have removed the screw, it is important that you remove grass and other dirt from the blade holder.
•
You can then insert the new blade.
•
Screw the blade screw in tightly. Check whether the blades can be turned.
Note: It is important that all 3 blades are reversed or replaced at the same time.
Battery:
•
In general, the battery life is 5 years, depending on the workload and maintenance of the robotic lawnmower.
Storage in winter:
•
We recommend that you store the robotic lawnmower plus charging station in a dry and frost-free room over the
winter after you have removed grass and other dirt (only with a dry cloth and scraper).
Manual_FX-RB218_Int24_rev1
on the robot.
Note: Always use original/authorised spare parts!
43
Advertenties
Inhoudsopgave
