Inhoudsopgave
Advertenties
•
Carefully clean the charging tentacles of the docking station and the copper plates of the machine to prevent
corrosion. Polish with steel wool and apply a little acid-free oil.
Note: You should charge the device every 2 months in winter to maximise the service life of the
Software update
Update software via USB:
•
Save the software on an empty USB data carrier
•
Switch off the robotic lawnmower and insert the USB stick
•
Switch on the robotic lawnmower and you will see a flashing number on the screen.
•
When the flashing stops, the software has been successfully updated;
•
Switch the robotic lawnmower off and then on again to check whether the desired software is displayed on the
screen.
•
Desired software on the screen.
•
Uxxx stands for the software of the main board, Cxxx stands for the limitation software.
17. Status/error messages
As a quick guide in the event that the robotic lawnmower is not working properly, you can view the
error codes on the device or follow the troubleshooting steps below to solve the problem. If the
error persists, please contact Fuxtec customer service.
Error message on the robot:
Display
E1
Emergency switch activated.
E2
Lift sensor activated.
E3
The robot is outside the boundary wiring.
E4
Boundary wire is broken.
E5
Obstacle/contact sensor activated.
E6
Power consumption on left drive motor too high.
E7
Power consumption on right drive motor too high.
Manual_FX-RB218_Int24_rev1
extend the battery life.
Error
description
battery.
Action
Restart the robot.
Is the wheel blocked? Remove the
obstacle and restart the robot.
Place the robot inside the boundary
wire.
Is the LED flashing red? Repair the
boundary wire and restart the
robot.
Are there any obstacles? Restart the
robot.
Is the grass too high? Over 4 cm? Is
the left wheel blocked?
Restart the robot.
Is the grass too high? Over 4 cm? Is
the right wheel blocked?
Restart the robot.
44
Advertenties
Inhoudsopgave
