Inhoudsopgave
Advertenties
Lifting sensors:
•
These sensors are located near the 2 front wheels and measure the contact of the wheels with the surface.
•
If the robot is lifted manually or if one or both wheels run into a hole, the robot switches off and must be restarted
manually.
•
A restart on the lawn can only take place if you move the machine so that it is at a maximum distance of 50 cm from
the boundary wire.
•
To start, you must select the area and then press the "START" button. The work cycle is not changed.
Tilt sensor:
•
A 6-axis sensor is integrated into the robotic lawnmower, which measures the angle of inclination in all directions.
•
If the angle of inclination exceeds 20°, the blades are stopped immediately, but the robot continues to move.
•
If the angle decreases again within 10 seconds, the blades restart automatically. However, if the angle does not
decrease within 10 seconds, the mower switches off and requires a manual restart.
•
A restart on the lawn can only take place if you move the machine so that it is at a maximum distance of 50 cm from
the boundary wire
•
To start, you must select the area and then press the "START" button. The working cycle is not changed.
16. Maintenance and winter storage:
To get the most out of your robotic lawnmower, it is important that you inspect the machine and its
mowing area regularly.
Regular cleaning:
•
You will extend the service life of your robotic lawnmower if you keep it clean regularly by removing leaves, branches
and dirt.
Note: It is very important to ONLY use a brush or dry cloth for cleaning. The use of water can damage
Top cover
•
Lift the top cover and clean it with a soft brush to remove grass and dirt. You can wipe it with a damp cloth (DO NOT
rinse with water because of the electronics).
Underside
•
Also clean the underside with a soft brush.
•
Ensure in particular that the blades and the blade holder can rotate freely.
If the robotic lawnmower frequently runs in wet grass, more grass automatically settles in the cutting chamber.
This significantly reduces the cutting performance and it is therefore very important to remove the grass. You also
Manual_FX-RB218_Int24_rev1
the electrical system.
Note: Remember to switch off the mains switch before cleaning!
need to clean the rotor blades regularly so that they can rotate.
42
Advertenties
Inhoudsopgave
