Inhoudsopgave
Advertenties
•
Remove the boundary wire, wire connections, pegs and the distance meter from the box.
•
You will also need: Hammer, pliers, spanner
Prepare the lawn:
•
The grass should not be higher than 60 mm when the boundary wire is inserted. If it is higher, it is advisable to mow
the lawn with a normal lawn mower first. The wire can then be laid as close to the ground as possible, which prevents
the robotic lawnmower from cutting the wire and people from tripping over it. After a short time, the wire will
disappear into the turf.
Lay the boundary wire:
•
Place the robot's charging station as indicated on your sketch (on the side) and insert the starting peg. Make sure
that you reserve 0.5 m of additional cable for the final installation of the docking station.
•
Lay your cabling loosely around the work area in the garden according to your sketch. You can then easily adjust it
as you go along.
•
Now you can start inserting the pegs. Keep the desired distance to the edge (35 cm) with the help of your measuring
boxes. The distance between the pegs must not exceed 1 metre. We recommend placing the pegs closer together
in the corners, which should always be at least 100°.
•
If there are areas in your lawn that you do not want your robot to mow, surround the area with boundary wire as
indicated.
Note: max. 5 mm between incoming and outgoing boundary wire
•
Insert the last peg when you are back at the charging station.
•
If the 100 m cable supplied is not sufficient, you can purchase additional cables. Use the supplied cable connections
for installation. You do not need to strip the wire ends for installation.
Connect the boundary wire to the charging station:
•
The connectors included in the scope of delivery must be clamped to the cable using flat-nose pliers.
•
When you connect the wire ends to the charging station, there is an IN wire and an OUT wire as indicated. The IN
wire is threaded through the wire holder under the charging station and must be connected to the IN plug, while
the OUT wire must be connected to the OUT plug (see following pictures).
Manual_FX-RB218_Int24_rev1
(see drawing).
35
Advertenties
Inhoudsopgave
