Advertenties
11. Charging station display and troubleshooting
LED indicator
LED indicator
Off
Off
Lit red
Lit green
Lit red
Flashing green
Flashing red
Flashing green
Flashing red
Off
12. Robot lawn mower display and troubleshooting
If an error code appears on the display, it can be reset as follows:
Enter the PIN and then press "START" and "OK" to make the robot lawn mower continue wor-
king, or press "HOME" after entering the PIN, followed by "OK", to send the robot lawn mower
back to the charging station.
Display
BACK
-
REST
-
GO
-
LOAD
-
FULL
-
STOP
-
Lift
The mower has
been lifted
ZONE
-
Anl_FREELEXO_SPK13.indb 44
Anl_FREELEXO_SPK13.indb 44
GB
Description
No power supply
Ready for mowing
The perimeter wire is properly con-
nected
The battery is fully charged
The perimeter wire is incorrectly
installed
The robot lawn mower is in the char-
ging station and the perimeter wire
is incorrectly installed
The battery is being charged
Fault
Possible cause
The mower is returning to the char-
ging station
The mower was set to "Pause"
mode in the app
The robot lawn mower is in working
mode
The lawn mower is in the charging
station and is being charged
The battery of the robot lawn mower
is fully charged
The STOP button has been
pressed.
The lifting sensor has been trig-
gered
Learning new starting points
- 44 -
Solution
Check the power supply
Inspect the perimeter wire for
breakage
Check the connections to the char-
ging station
Wait until the battery is fully char-
ged.
Remedy
Enter the PIN and select the next
action to be taken
If this fault occurs frequently, check
the mowing area for obstacles taller
than 10 cm and either remove them
or cordon them off from the mowing
area with the perimeter wire (18).
31.10.2024 13:26:13
31.10.2024 13:26:13
Advertenties
