Inhoudsopgave
Advertenties
5
INSTALLATION AND COMMISSIONING
5.1
Unpacking the machine
Machines are delivered from our works on pallets, strapped and protected with cardboard. First of all,
the packaging must be examined and any damage caused in transit must be declared directly to the
carrier.
A. Remove the cardboard.
B. Remove the side doors from the machine in order to gain access to the screws securing
the machine to the pallet.
C. Detach the machine from its pallet by removing the 2 screws immobilising the machine
(fig.5).
D. Take the machine off the pallet. Make sure you do this with at least two people in order to
lower it as gently as possible onto the floor.
E. (TRADIFORM/DIVIFORM/DIVIFORM+) Fit the frame onto its mounting (fig.6).
F. (EASYFLOUR Option) Install the flour dispenser and fill it with flour (fig.6).
After unpacking the machine, check that it has not been damaged in transit. Notify us
of any defects.
5.2
Location
In order to achieve excellent performance and long-term reliability, choose a location that is:
Well ventilated, shielded from direct sunlight and away from sources of heat, with a flat and
sturdy surface free from vibration.
5.3
Electrical connection
IMPORTANT: This machine must be earthed.
It is recommended that the system be protected with a fuse and an RCD.
Your mains electricity supply to the machine must be protected as indicated below:
- North America: 15 A protection;
- Rest of the world: 16A protection.
For machines equipped with a variable speed drive, it is imperative that they be connected to a
junction box on a circuit fitted with a type B 300 mA differential.
Note: Any problem resulting from any other type of connection will not be covered under warranty.
Before connecting the machine to the mains supply and in order to prevent motor failure when it is
switched on, it is important to check that the mains supply matches the machine specification (see
machine nameplate).
9
English
This machine complies with Machinery Directives 2006/42, 2014/35, 2014/30 and is CE-marked as
proof of this compliance.
Please familiarise yourself with the safety pictograms displayed on the machine:
This pictogram indicates an electrocution hazard. Please isolate the machine
before carrying out any work on it. You will find this pictogram inside the machine
on the electrical enclosure (fig.13, n°21).
You will find the circuit diagram for the machine inside the left-hand door of the
divider (fig.13, n°22).
This pictogram indicates a crushing hazard. Please isolate the machine before
carrying out any work on it. You will find this pictogram on the side doors (fig.13,
n°23).
5.4
Commissioning
Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
Ensure first of all (after verifying electrical compatibility) that the motor is rotating in the right direction;
if so, the heads will rise when you pull the control lever towards you. If this is not the case, disconnect
the plug and switch 2 phases in it.
For machine operation, refer to the "Operation" chapter.
5.5
Hazard
If the user or the machine is in danger, use the emergency stop to stop the machine.
Remove the plug from the mains socket before any maintenance and/or servicing work.
Any maintenance work or replacement of parts must be carried out by an approved agent.
English
10
Advertenties
Hoofdstukken
Inhoudsopgave
