Inhoudsopgave
Advertenties
Installation site:
Assembly-
company:
Assembler:
Assembly environment as expected
(place and diagram are consistent)
Assembly corresponds to manufacturer's data
Recommended fastening-related specifications fulfilled
Test report - Acceptance test before initial operation in conjunction with steel structures
1. Tasks carried out
1.1 Checking the proper assembly of the AP-fix anchorage point
1.1.2 Assembly and assembly drawing are consistent with each other
1.1.3 Checking the tight fit of the fastening nuts (quality factor 8.8 - SSI), tightening torque - point 3.2
1.1.4 Checking the tight fit and functioning of the AP-fix anchorage point
1.1.5 Identification mark of the anchorage point is available and legible
1.1.6 If necessary, carry out a test loading procedure. Otherwise, proceed with point 3.1
2. Test method used: Test loading in accordance with the principle of preliminary tension
2.1 Function description: A torque wrench is used to apply a testing torque of 35 Nm to the screw socket
of the test load device. This testing torque gives rise to a tensile load of 13 kN in the anchorage point. If the
permissible twist angle of 135° is not exceeded, the slippage lies under 0.2 mm, in which case the
anchorage point passes the test.
2.2 Test: The concrete surface was cleaned. Each anchorage point was subjected to two test loads.
The first application of the testing torque served to level out the roughness of the concrete vis-à-vis the
contact surfaces of the testing device. The anchorage point was then unburdened, and the position of the
testing device was not changed. The second measurement started with the application of a distortion
moment of 5 Nm. The 0°-mark of the angle scale was placed on the mark on the screw socket. The testing
torque of 35 Nm was applied. The twist angle is to be read out at the scale.
3. tested devices:
Unit
name
3.1
name
3.2
Unit
4. The following defects were detected :
5. Remarks :
Date of next test:
Qualified person
ENGLISH
Test report
product no
product no
Place, date, client's signature
20
Image documentation
minimum component thickness
minimum edge distance
minimum axial distance
testing torque
tightening torque of the nuts
screw socket
angle scale
twist angle
Fig (1) Test loading device
Advertenties
Inhoudsopgave
