Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en
Cleaning and maintenance
Caution!
– Check that the foot is at the right height.
– It should not be possible to turn the
attachment any further.
5. Attach the filling tray.
Caution!
Never use without the filling tray! The pusher
will otherwise block the worm gear and the
accessory damaged.
6. Prepare your food. Chop up large parts
beforehand so they fit into the feed chute
without having to press them in.
7. Plug the mains plug into the mains. Turn
the rotary switch to the recommended
setting.
8. Place a suitable container under the
attachment. Add the prepared food to the
filling tray.
9. Use the pusher to slide the food down
the feed chute, applying light pressure.
10. Once you have finished work, move the
rotary switch to y. Wait until the drive
comes to a standstill. Disconnect the
mains plug.
11. Remove the filling tray and pusher.
12. Hold down the release button and rotate
the attachment in a clockwise direction
until it disengages.
13. Remove the attachment and take apart.
14. Open the locking lever on the bevel gear.
Rotate the bevel gear in an anticlockwise
direction and remove.
■ Clean all parts directly after use.
X "Cleaning and maintenance" see
page 12
Cleaning and maintenance
The attachments and accessories used must
be thoroughly cleaned after each use.
Caution!
– Do not use any cleaning agents
c ontaining alcohol or spirits.
– Do not use any sharp, pointed or metal
objects.
– Do not use abrasive cloths or cleaning
agents.
– Never clean the bevel gear under
running water or put in the dishwasher.
12
In Fig. H you will find a summary of how to
clean the individual parts.
Cleaning the bevel gear
■ Wipe the outside of the bevel gear with
a soft, damp cloth and dry off.
Cleaning the attachments
■ Dismantle the attachments used into
their individual parts. To do so, proceed
in in reverse order, as described under
"Preparation" for the relevant attachment.
■ Remove the lid of the pusher before
cleaning and take out any accessories
inside.
■ Clean all accessories with a detergent
solution and a soft cloth/sponge or with
a soft brush.
■ Allow all parts to dry.
Please note:
– Some parts can also be washed in the
dishwasher. X Fig. H
– Immediately rub metal parts dry and
apply a little cooking oil to protect them
from rust.
– When processing food such as carrots,
plastic parts may become discoloured.
This can be removed with a few drops of
cooking oil.
Storage
X Fig. I
The pusher includes a storage compartment
for the parts of the sausage filler and kebbe
insert as well as for the perforated discs.
Place the parts in the pusher as shown and
close with the lid.
Overload protection
To prevent serious damage to your appliance
if it is overloaded, the agitator paddle has
a notch on the worm gear ( p redetermined
breaking point). If o verloading occurs, the
agitator paddle will break at this point. A new
agitator paddle is available from customer
service (No. 10001090). Spare parts with
a pre d etermined breaking point are not
covered by our warranty obligations.
Advertenties
Inhoudsopgave
