Inhoudsopgave
Advertenties
EN
Scan for
Daily Maintenance
Poster
1
2
A
After use, empty waste water tank using emptying hose and flush out
A
with clean water.
Next remove floor tool vacuum hose and flush out with clean water.
B
Next empty clean water tank, using emptying hose and again flush out
C
with clean water.
IMPORTANT
If the debris basket is allowed to become clogged, vacuum
performance can deteriorate.
Located under the left hand side is a clean water filter, make sure the
clean water tank is empty before removing this filter.
Note: To make access easier, raise the brush deck.
Regular Maintenance
!
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED
OFF PRIOR TO ANY MAINTENANCE REMOVE BOTH
BATTERIES PRIOR TO ANY MAINTENANCE OPERATION.
Remove the two hoses to disconnect the separator from the
machine (Fig 1).
Whilst pulling the top tank separator toggles up and
inwards, remove the separator. (Fig 2)
The separator has a sealing rubber which should be
examined at every clean-down.
Rinse using clean water, avoiding the vac filter.
Remove the filter fitted into the separator and flush with
clean-water (Fig.3)
IMPORTANT
Remove vac filter and clean if required (keep dry).
Never use the machine without the recommended filter as it
may cause damage to the machine.
Remove debris basket filter and rinse using clean water, and
refit. (Fig 4)
B
C
A
53
53
!
3
4
C
Advertenties
Inhoudsopgave
