EN
Raising/Lowering the Floor Tool
After preparing the floor (see previous section), we are now
ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush
deck is lowered. Move the floor tool lever to its
lower position.
Note: Do not pull the machine backwards with
the floor tool in the lowered position, this could
possibly damage the blades.
The floor tool design incorporates a break-away feature.
Allowing it to safely disengage from its mounting should it become caught on an obstruction,
during forward machine movement.
To re-attach the blade to its holder. First loosen the retaining knobs on the floor tool body and slide onto the holding bracket.
Tighten retaining knobs to finger tight.
Raising/Lowering the Brush Deck
To tip the deck into the down position (Operating mode). Press in the brush
deck locking pin (Fig.A)
and rotate the brush deck (Fig.B & C). To change to brush deck up position,
(Transit mode) simply lift the deck and the spring loaded locking pin will
activate to hold the deck up.
A
Machine Operation
B
31
31
Break-away Floor Tool
C