Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
11 DRAWINGS
A. DISPOSABLE HEAD
1
Threaded shaft
2
Head calibration value
3
Blade housing
4
Slide
5
Blade
6
Aplanating plate
B. SUCTION RING
1
Vacuum port
2
Threaded shaft
3
Guiding
4
Stopper with engraved stop value
5
Handle
C. SETTING THE STOPPER
1
Spanner
2
Stopper
D. CONNECTING THE SUCTION RING TO THE
ASPIRATION TUBING
1
Aspiration tubing end
2
Tubing of the suction ring
E. MOTOR
1
Motor housing
2
Motor cord
3
Threaded ring
4
Oscillation motor shaft
5
Head alignment guide
6
Advance drive
F. MOUNTING THE HEAD ON THE MOTOR
1
Open the pack containing the disposable
head and suction ring
2
Screw the head clockwise onto the threaded
motor shaft.
3
Check that the head is screwed on tightly to
the motor. There should be no rotation of the
head.
G. MOUNTING THE HEAD ON THE SUCTION
RING
1
When inserting the head in the rails of the
suction ring, the handpiece must be at a 45°
angle from the threaded shaft of the ring
2
Once the head properly inserted, slightly
reduce the angle from 45° to 0°
3
Carefully engage the head into the ring
Document Aletiq : Rév. J-05.2023 (Validée)
12
MORIA
#65039-J-05.2023
H. ALIGNMENT OF THE HEAD, MOTOR AND
SUCTION RING
1
Proper assembly
2
Incorrect alignment
3
Alignment of the threaded shaft with the
motor
I. CLEANING THE MOTOR
1
Disposable brush (#19149)
2
Maximum submersion
3
Sterile distilled water
Advertenties
Hoofdstukken
Inhoudsopgave
