Advertenties
Beschikbare talen
Beschikbare talen
USER MANUAL
OPERATING GUIDE
WARNING!
Pay high attention to these symbols in this manual:
– DANGER
– WARING
– CAUTION
– CONSULTATION
Never cover these symbols on the machine for any reason, replace it immediately if any damage.
INSTALLING AND SETTING OF NEW MACHINE BATTERY
WARNING!
The electric components of the machine can be seriously damaged if the batteries are either improperly
installed or connected.
The batteries must be installed by qualified personnel. Set the battery charger (optional) and machine PCBA
according to the battery type (WET or GEL/AGM).
Check the batteries whether it is damaged before installation.
Disconnect the battery connector and the battery charger plug.
Handle the batteries with great care.
NOTE
The machine requires two 12V batteries, connecting according
to Figure 3.
The machine can be operated in one of following battery modes:
A) WET or GEL/AGM batteries are already installed and ready to
be used
1.
Check the batteries and connect the battery connector to the machine.
2.
Insert the key switch (40) and turn to "on". If the green light (48) turns on, batteries are full charged for use; If the
yellow or red light (47 or 48) turns it on, the batteries must be charged.
B) Without Batteries
1.
If your machine isn't equipped with batteries, buy appropriate batteries *See the Technical Data Paragraph+. For
battery choice and installation, turn to qualified battery Retailers.
2.
When batteries are ready, set the machine and the battery charger according to the type of installed batteries,
then follow the procedures shown in the next paragraph.
BATTERY INSTALLATION AND BATTERY TYPE SETTING (WET OR GEL/ AGM)
Set the electronic circuit board of the machine and battery charger according to battery types (WET or GEL/AGM)
following steps below:
NOTE
When install new batteries, follow Figure 4 to set DIP switch, or batteries may be damaged by wrong
setting.
Machine setting
1. Insert key switch (40) and turn to "ON", pay attention to below during the first seconds of machine start:
If the green light (37) flash, machine is set up to use GEL/AGM batteries.
If the yellow light (33) flash, machine is set up to use Discover EV AGM batteries.
If the red light (32) flash, machine is set up to use WET batteries.
2. Follow below steps to change the machine settings.
3. The factory setting of the machine is to use Discover EV AGM batteries. If the setting corresponds to selected
batteries, go to step 6 directly, or follow the next step.
!
!
!
9
ENGLISH
Figure 3
Advertenties
