Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7.9 Cleaning the condenser
The condenser may be cleaned solely
by a specialized technician, who must
organize all of the operational
sequences and use suitable
equipment, in strict compliance with
the applicable regulations currently
in force.
Periodically clean the condenser
situated inside the machine.
Warning: Removing safety guards will
expose some sharp surfaces of the
machine.
dirty condenser will impair machine
performance.
To access the condenser remove the safety guards.
It is forbidden to use the machine when even
only one panel(front, rear or side) is not set
properly in place, it is prohibited for the
operator to clean the condenser.
The safety guards must be removed by means of a
suitable screw driver.
Remove the rear guard after taking out the screws
securing it to the frame (the screws are positioned on the
left and right sides After removing the guard, use a dry
brush to remove the dust that has built up over time with
use.
Once the condenser has been thoroughly cleaned, fit all
the safety guards back in position.
To remove the safety guard panel, proceed as follows:
-Lift and completely remove the upper part of the side
guard.
-Unscrew the 4 screws securing the guard in place.
-After removing the 4 screws, take off the guard.
After removing the guard, use a dry brush to remove the
dust that has built up over time with use.
After having thoroughly cleaned the condenser,
reassemble all the safety guard components.
www.combisteel.com
19
Advertenties
Inhoudsopgave
Probleemoplossen
