Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. INSTALLATION
All of the operations described in chapter 5
may be carried out exclusively by specialized
technicians, who must organize all the
operational sequences and use suitable
equipment, in strict compliance with the applicable
regulations currently in force.
The machine must be installed indoors in a well-lit and
well-ventilated room with a firm, solid, level floor (slope
less than 2°).
The machine is of the attended type, and must
be installed in places where it can be
monitored by trained personnel.
Warning: it is forbidden to install the machine
in a place where it may be reached, touched
and/or operated by persons other than those
specified in section 1.2.
The machine may only operate in places with an ambient
temperature ranging between 20°C and 32°C.
5.1 List of accessories provided
Vaseline: to lubricate all of the parts indicated in this
manual after washing and sanitization operations.
5.2 Installation-Positioning
The installer must check that:
•
the site has: been duly prepared for machine
installation;
•
the surface the machine will be installed on is firm,
fat and solid;
•
the room is adequately lit, ventilated and hygienic
and an electric outlet is within easy reach
Adequate clearance must be left around the
machine to enable personnel to work
without any constraints and also to leave the
work area immediately in case of need.
The figure below shows the minimum clearances for
installation.
5.3 Disposal of packing materials
After opening the box, make sure to separate the packing
materials according to type and dispose of them in
accordance with the current regulations in the user's
country.
We recommend keeping the box for future conveyance
or transport.
5.4 Electrical connection
Before plugging in the machine, make sure that the main
switch is on "OFF"
The Purchaser is responsible for making the electrical
connection The machine must be connected to the
electricity mains by means of the plug fitted on the
power cord. Be sure to comply with the technical
regulations and standards in force at the time of
installation;
the data shown on the rating plate on the side of the
machine.
disconnect the machine from the power supply when
necessary.
lf the power cord is damaged, you must have it replaced
either by the manufacturer or a specialized technician
www.combisteel.com
This job may be performed only by
specialized technical personnel.
Warning: the electric outlet must be situated
in a place easily within reach of the user, so
that no effort is required in order to
It is forbidden:
to use extension cords of any type.
to replace the original plug.
to use adaptors.
10
Advertenties
Inhoudsopgave
Probleemoplossen
