Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Apply seal (B), lubricating the entire surface indicated by
the arrows with Vaseline.
Introduce the auger, engaging head (C) with shaft (D).
Rotate the auger to engage it.
Set the bowl back in place: slightly raise head (C) of the
auger so that it meets the seat provided (E) in the bowl.
Press the bowl downward until it engages the surface as
shown in the figure.
Follow these instructions to refit the tap:
1. using the Vaseline provided, adequately lubricate the
cap (Y), and refit the components，
2. introduce the pin (F) while keeping the tap lever steady.
Correctly install the components as shown in
the figure. The non-lubrication of the cap may
cause product leakage from the tap.
7.6 Rinsing cycle
Before starting up the machine, you must carry out the
rinsing cycle.
Proceed as follows:
1. fill the tank with clean water.
2. let the machine on for 5 minutes in the "agitation"
mode only.
3. turn off the machine and empty the tank by opening
the tap.
www.combisteel.com
17
Advertenties
Inhoudsopgave
Probleemoplossen
