Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7.7 Cleaning the drip tray
The drip tray should be emptied and cleaned daily.
All of the drip trays present in the machine
should be cleaned The drip tray should be
emptied and cleaned every time the red float
installed in the grid rises into view.
Holding the drainage hose firmly, lift the tray with the
grid on top of it and pull it out.
Wash the tray and grid separately with lukewarm water!
Dry all of the components.
Reposition the grid on top of the tray.
Position the drainage hose in the opening provided.
Fit the tray back in place and press down to secure it to
the machine.
7.8 Lighted lid
Maintenance of the lighted lid must be
entrusted solely to a specialized technician,
who must organize all of the operational
sequences and use suitable equipment, in
strict
compliance
regulations currently in force.
The operator is forbidden to disassemble any
lid component.
Clean the lid contacts using a wet cloth, and dry carefully.
Always carry out this operation when the machine is off.
with
the
applicable
www.combisteel.com
Warning: during the cleaning operations,
take care not to dam-age (bend, break, etc.)
the contacts; any damage might cause a bad
functioning of the lid, which is not under warranty.
7.8.1 Bulb replacement
The bulb must be replaced only when the
main switch is in position "OFF" and power
cord is unplugged.
Remove the protection caps; undo bath screws to split
the lighted lid sections: use a proper screw-driver for this
operation.
Remove the bulb "U" from the socket "T", and replace it
with a new one refit the lid, and tighten both screws.
18
Advertenties
Inhoudsopgave
Probleemoplossen
