Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
b. First loosen the locking ring (pull the cable down to make it easier). This gives you the
space to tighten or loosen the adjustment screw under it (Figure 71).
c. Tighten the locking ring again and check if the brake provides the desired braking force.
d. Do the same on the other side and check if both brakes offer the same resistance.
Brake adjustments at the bottom of the brake cable
If you need to tighten the brakes more than what the top adjustment will allow, you can further
adjust using the bottom brake adjustment.
a. The Rollz Motion Electric should not be on the parking brakes while adjusting the brakes.
b. Stay at the rear of the Rollz Motion Electric when adjusting the brakes. Loosen the
locking ring at the bottom of the brake cable (pull the cable up to make it easier). Turn
the adjustment screw above it to shorten or extend the brake cable (Figure 72).
Turn clockwise for more braking power, and anticlockwise for less braking power.
c. When the brake has the desired force, tighten the locking ring.
d. Do the same on the other side.
e. Check whether the braking force on the left and right side is evenly distributed.
CAUTION
If the brakes do not function properly after adjusting them, contact your supplier
immediately and do not use the Rollz Motion Electric.
Figure 72:
(dark orange) and the adjusting screw.
Brake adjustment via the circlip
55
Advertenties
Hoofdstukken
Inhoudsopgave
