Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Attaching the joystick controller
a. Make sure the cable of the joystick controller is disconnected before attaching
it. Disconnect by loosening the metal rings. Slide the disconnected joystick
controller through the hole in the holder. Make sure that the cable runs
between the frame and the controller as shown in (Figure 4).
b. Reconnect the cable, and tighten the controller by rotating the knob
(Figure 5).
Figure 4:
Slide the
joystick controller into
the holder.
Attaching the 3-in-1 holder
The 3-in-1 holder can be put in place without any tools:
a. Slide the armrests as far back as possible, the two holder should be placed
in front of the armrests, with the shopping hooks facing outside, as seen on
Figure 6.
b. Attach the holders by pressing it down onto the frame (Figure 6).
c. The 3-in-1 holder can hold the wheelchair package (above the seat), a cane
and a shopping bag at the same time.
d. Follow the instructions on the manual that comes with the 3-in-1 holder to
see how to place the wheelchair package, the cane and the bags into the
holders.
e. The Rollz Motion Electric can also be used without the 3-in-1 holder.
NOTE
Do not place more than 2.5 kg / 5.5 lb in each bag and do not overload it.
3
2
1
Figure 5:
Connect (1&2)
and tighten (3) the
controller.
17
Advertenties
Hoofdstukken
Inhoudsopgave
