Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Setting the backrest (once only)
Adjustment straps are placed in the backrest of the Rollz wheelchair package. For
optimal seating comfort, it is important to adjust these adjustment straps to the user.
It is only necessary to do this for the first use - or if the user has undergone major
changes in weight.
a. Turn the Rollz Motion Electric into an electric wheelchair (Figure 47)
and remove the footrests from the wheelchair package bag.
b. Pull up the bag of the wheelchair package and the backrest cover from
the bottom (Figure 50). The adjustment straps are now clearly visible
(Figure 51).
c. Adjust the straps by pulling off the Velcro and fastening it again to the
desired setting (Figure 52).
d. In most cases, the lower straps will be adjusted looser than the upper two
straps (Figure 53). Attach the Velcro so that the user's pelvis is properly
upright, and the backrest supports the back.
e. Put down the backrest cover and the wheelchair package bag.
f. Check if the user is comfortably in a correct sitting position (Figure 54).
CAUTION
Ensure the straps in the backrest are properly adjusted (see Setting the
backrest). If the seat depth is large enough, the weight of the person is placed as
far back in the seat as possible. That is safer for the user but also easier for the pusher
to push.
Putting down the wheelchair package
Follow these steps to turn the electric wheelchair into a rollator:
a. Remove the footrests. Slide the footrests up until released from the footrest
holders. Put them back into the bag of the Rollz wheelchair package, mirrored
to each other (Figure 55).
b. Grasp the handle of the wheelchair package and push the backrest forward
until halfway up the frame. Then lower the backrest down until it folds behind
the seat.
35
Advertenties
Hoofdstukken
Inhoudsopgave
