Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Brake performance (Daily)
Check the braking performance. When the brakes are in use, the wheels of the Rollz Motion
Electric should come to a stop. If the wheels do not stop when using the brake: immediately
shut down the system, check for damage and try to adjust the brakes according to the
explanation below. Contact the supplier if the brakes are damaged or when the braking
performance does not allow the Rollz Motion Electric to stop after adjusting. Do not repair the
brakes by yourself.
Adjusting the brakes
By using the Rollz Motion Electric, the brakes can wear out. As a result, it may be necessary
to readjust the brakes. When the brakes are correctly adjusted, you prevent problems and can
make optimal use of them. Check the brakes regularly, preferably before each use. When the
Rollz Motion Electric has the parking brakes applied, the wheels should not turn. When the hand
brakes are released, the Rollz Motion Electric should not be slowed down.
If the brakes do not work properly, they can be adjusted in two ways: at the top and bottom of
the brake cable (Figure 70). The adjustment at the top of the brake cable (just below the
height adjustment handle) is for fine-tuning, so the performance of the brake can be set a little
tighter. The adjustment at the bottom of the brake cable (near the rear wheels) is for a more
radical adjustment. Make sure that both the left and right brakes are properly adjusted.
Figure 70:
Brake adjustment via the
adjustment screws at the top and bottom
of the brake cable.
Brake adjustments at the top of the brake cable
You can tighten the brakes using the brake adjustment at the top.
a. The Rollz Motion Electric must not be on the parking brakes while adjusting the brakes.
54
Figure 71:
Brake adjustment via the
adjustment screw, just below the
locking ring.
Advertenties
Hoofdstukken
Inhoudsopgave
