Inhoudsopgave
Advertenties
Danger!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.
Explanation of the symbols used (see Fig. 7)
1. Danger! - Read the operating instructions to
reduce the risk of injury.
1. Safety regulations
WARNING!
Read all safety warnings, instructions, illust-
rations and specifi cations provided with this
power tool. Failure to follow all instructions listed
below may result in electric shock, fi re and/or
serious injury.
Save all warnings and instructions for future
reference.
Safety information on the measuring device
•
Keep the measuring instrument out of the rain
and away from moisture.
•
Keep the measuring instrument away from
direct sunlight.
•
Keep the measuring device away from ext-
reme temperatures and do not expose it to
extreme fluctuations in temperature.
•
Keep the measuring device away from flam-
mable gases, vapors and solvents.
•
Avoid damage and shocks.
•
After it is exposed to strong changes in tem-
perature, let the measuring device adjust to
ambient temperature for approx. 60 minutes.
Special information about the laser
Caution: Laser radiation
Do not look into the beam
Laser class 2
Anl_TC_IT_550_SPK13.indb 11
Anl_TC_IT_550_SPK13.indb 11
GB
VORSICHT ! - LASERSTRAHLUNG !
Nicht in den Strahl blicken!
Laserspezifikation
Laser Klasse 2;
: 630-670 nm; P: < 1 mW
nach EN 60825-1, EN 50689
•
Never look directly into the laser path.
•
Never direct the laser beam at reflecting sur-
faces or persons or animals. Even a low out-
put laser beam can inflict injury on the eye.
•
Caution: It is vital to follow the work proce-
dures described in these instructions. Using
the equipment in any other way may result in
hazardous exposure to laser radiation.
•
Never open the laser module.
•
It is prohibited to carry out any modifications
to the laser to increase its power.
•
The manufacturer cannot accept any liability
for damage due to non-observance of the
safety information.
Safety information on the batteries
Use of the batteries
•
Inserting the batteries when the laser is swit-
ched on can cause accidents.
•
If the equipment is not used correctly, the bat-
teries may leak. Avoid contact with the battery
fluid. If you come into contact with battery flu-
id, clean the affected body part with running
water. If you get battery fluid in your eyes,
seek immediate medical assistance.
•
Escaped battery fluid can cause skin irritation
and acid burns.
•
Never expose the batteries to excess heat
such as sunshine, fire or similar.
•
Never recharge batteries that are not suitable
for recharging. Risk of explosion!
•
Keep batteries away from children, do not
short circuit batteries or disassemble.
•
Seek a doctor's advice immediately if a batte-
ry is swallowed.
•
If necessary, clean the contacts on the
battery and equipment before inserting the
batteries.
•
Ensure that you insert the batteries the right
way round.
•
Remove flat batteries immediately from the
equipment. There is an increased risk of
leakage.
•
Always change all batteries in one go.
•
Insert only batteries of the same type, do not
- 11 -
05.12.2024 10:43:43
05.12.2024 10:43:43
Advertenties
Inhoudsopgave
