3
Fitting
ATTENTION:
IMPORTANT INSTRUCTIONS FOR SAFE FITTING.
OBSERVE ALL INSTRUCTIONS, INCORRECT FITTING
COULD RESULT IN SERIOUS INJURIES.
Risk of deadly electric shock from
mains voltage
Contact with the mains voltage presents the danger
of a deadly electric shock.
Only qualified electricians may work on the electrical
▶
connections.
Make sure that the on-site electrical installation
▶
conforms to the applicable protective regulations
(230 /240 V AC, 50 / 60 Hz).
If the mains connection cable is damaged, it must be
▶
exchanged by a qualified electrician to avoid danger.
Disconnect the mains plug before performing any work
▶
on the door system. Safeguard the system against
being switched on again without authorisation.
WARNING
Unsuitable fixing material
Use of unsuitable fixing material may mean that the operator
is insecurely attached and could come loose.
The fitter must check whether the supplied fixing
▶
materials (plugs) are suitable for the intended fitting
site. If required, use other material, as the included
fixing materials are suited for concrete (≥ B15), but not
officially approved (see Figures 3 .2 / 4 .4a).
WARNING
Danger of injury due to unwanted door travel
Incorrect fitting or handling of the operator may trigger
unwanted door travel.
Follow all the instructions provided in this manual.
▶
Incorrectly attached control devices (e.g. buttons) may
trigger unwanted door travel. Persons or objects may
be trapped as a result.
Install control devices at a height
▶
of at least 1.5 m (out of the reach
of children).
Fit permanently installed control
▶
devices (such as buttons, etc.)
within sight of the door, but away
from moving parts.
Crushing hazard during boom fitting!
There is a danger of crushing your fingers while fitting
the operator boom.
Make sure that your fingers do not get between
▶
the profile ends.
437784 B3 / 28-2021 / RE
DANGER
CAUTION
ATTENTION
Damage caused by dirt
Drilling dust and chippings can lead to malfunctions.
Cover the operator during drilling work.
▶
3 .1
Emergency release
The cord knob for mechanical release may not be installed at
a height greater than 1.8 m from the garage floor. The cord
may need to be extended on-site, depending on the height of
the garage door.
When extending the cord, please make sure that the cord
▶
cannot become caught on a roof carrier system or any
other vehicle protrusions.
An emergency release is necessary for mechanical release
for garages without a second entrance. An emergency release
prevents the possibility of being locked out during a power
failure. Order the emergency release separately
(see accessories C7).
Check the emergency release monthly for proper
▶
function.
ENGLISH
11