5. Troubleshooting
PROBLEMS
5.1 – If the nasal
Batteries might be partly exhausted. Remove and replace batteries.
douche nebulises
Check that the atomizer (3) has been positioned correctly.
poorly or for a
Check that the nasal douche is clean and, if not, clean it again by carefully following
short time.
the instructions reported in the manual regarding Cleaning, Sanitization,
Disinfection and Sterilization.
5.2 – If the nasal
Batteries might be partly exhausted or positioned wrongly. Remove and replace
douche does not
the batteries.
nebulise
Check that the solution has been poured in correctly in the nebulisation slot (4a)
of the flask (4).
Check that the quantity of liquid is not above 15 ml.
If using an aerosol medicine, check that it has been sufficiently diluted with
physiological solution 0,9% (strictly follow the doctor's prescription).
Check that the nasal douche is clean and, if not, clean it again by carefully following
the instructions reported in the manual regarding Cleaning, Sanitization,
Disinfection and Sterilization.
NOTE: If after verifying the abovementioned conditions the device still does not nebulise, we
advise you to contact your seller or the authorized assistance centre.
6. Technical characteristics
Model:
Input voltage
Max capacity of the nebulisation slot
Nebulisation time for 10 ml of physiological solution NaCl 0,9% about 2 minutes (1 ml about 12
seconds)
Cumulative Percentage of Mass Oversize > 10 microns between 95 and 96 %
(Non-respirable fraction useful for the treatment of the upper respiratory tract) -
Malvern Mastersizer according to the procedure of the Pharmaceutical Department of the University of Padova.
Nasal douche dimensions
Nasal douche weight (no batteries)
Complying with directive 93/42 ECC
Approvals:
Nasal douche batteries
Conditions of use:
Storing conditions:
Atmospheric pressure in operating/storage conditions: min. 690 hPa; max. 1060 hPa P
Applied BF-type parts are:
Disposal: For an adequate disposal, remember that the device contains batteries. In compliance with Directive 2012/19/EC, the
symbol on the device indicates that the device to dispose of is considered as waste, and should therefore be disposed of
accordingly. The user shall take the abovementioned waste (or have it taken) to a proper separate collection of waste centre
created by local administrations, or hand it in to the seller when buying a new device of the same kind. The separate collection
of waste and the following operations of treating, recycling and disposal, favour the production of devices with recycled
materials and limit the negative effects on the environment and on health, caused by unappropriate waste handling. The unlawful
disposal of the product by the user could result in administrative fines as provided by the laws transposing Directive 2012/19/EC of
the European member state or of the country in which the product is disposed of.
Electromagnetic compatibility
This device was designed to satisfy the currently required requisites for electromagnetic compatibility (EN 60601-1-2). Electro-
medical devices require particular care during installation and use relative to EMC requirements. Users are therefore requested to
install and/or use these devices following the manufacturer's specifications. There is a risk of potential electromagnetic interference
with other devices. RF mobile or portable radio and telecommunications devices (mobile telephones or wireless connections) can
interfere with the functioning of electro-medical devices. For further information visit our website www.flaemnuova.it. The appliance
may be susceptible to electromagnetic interference in the presence of other devices used for specific diagnoses or treatments. Flaem
reserves the right to make technical and functional modifications to the product with no prior warning.
SOLUTIONS
P0709EM
3,0 Vdc – 4,5 W
15 ml
Values measured with a computerized laser diffractometer
(1)
7x6x15,5h cm
185 g
2 1,5 V alcaline batteries (AA type)
Temperature: min +5°C; max 40°C
Air humidity: min 15%; max 90% RH
Temperature: min -10°C; max +45°C
Air humidity: min 10%; max 75% RH
(1A-1B-1C)
11
(1)