Advertenties
Beschikbare talen
Beschikbare talen
Depth calliper
WARNING!
Each 3 or 4 chain (1) sharpening operations check and, if necessary, file the depth marker by means of a flat
file, then round its tip.
6.1.6
End of work maintenance
•
Follow all the maintenance instructions described in the manual.
•
Empty the oil reservoir (14) and close its plug (12).
•
Remove the cutting residues (sawdust) from the front cover (5), then reassemble and perfectly clean the tool.
•
Insert the cutting bar into its guard (15).
WARNING!
Periodically disassemble the front guard (5) and eliminate the cutting residues which could obstacle the tool
perfect performance.
6.2
Special maintenance
WARNING!
Any special maintenance operation must be carried out at an Authorized Service Point.
AUTHORIZED SERVICE POINT
It is the Service Point authorized by the Manufacturer for repairing the products.
6.3
Periodic maintenance table
Check chain lubrication.
Check the condition and tension of the chain.
Check the condition of the bar.
Check the efficiency of the safety catches and protections.
Check and top up the oil
Remove cutting residues.
Check the chain pinion for wear.
Battery holding recharge. Necessary to prevent it from dropping below
15V (no longer rechargeable).
Overhaul to be carried out at a Manufacturer's Authorised Assistance
Centre.
Use and maintenance manual – Translation of
original Instruction.: 03, Date 16/12/2022
MAINTENANCE
File till it is as flat
as the calliper
X
X
X
X
X
Round the
angle
ROUTINE
EXTRAORDINARY
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Page 41
Advertenties
